Swapping out worn thumbsticks on a 360 pad

• 
  NeoTrix[helper]1 year, 4 months ago1 Like #1Show comment toolsReply

  is easy, remove all the screws, there is a small board inside, unscrew and pop them off, just make sur eyou dont lose any parts. i changed mine in about 5-10 mins, there are vids on yourtube to help.
• 
  DLM1 year, 4 months ago #2Show comment toolsReply

  Wowsers!
• 
  CheapAssGamer1 year, 4 months ago #3Show comment toolsReply

  You may need a torx t8 screw driver, but v easy to do.
• 
  fruman231 year, 4 months ago #4Show comment toolsReply

  NeoTrix

  is easy, remove all the screws, there is a small board inside, unscrew and pop them off, just make sur eyou dont lose any parts. i changed mine in about 5-10 mins, there are vids on yourtube to help.

  
  Cheers mate, had a 360 controller in bits before, but that was for something different, not something i make a habit of doing.
• 
  fruman231 year, 4 months ago1 Like #5Show comment toolsReply

  CheapAssGamer

  You may need a torx t8 screw driver, but v easy to do.

  
  Got one with the thumbstick pack, sure i've got a set kicking around but having spares never hurt anyone.
  
  Cheers for the replies.
• 
  sme241851 year, 4 months ago #6Show comment toolsReply

  very easy i modded mine to have bullets in buttons

Post a Comment