Nest Learning Thermostat S-Plan Installation

7
Found 20th Sep 2016
Hi,

I am looking to get a 3rd generation Nest Learning Thermostat installed and need some advice.

We currently have a Glow Worm System Boiler (Ultracom2 30SXI) which is connected to Glow Worm Smart Wiring Centre 2 (See photo), Glow Worm Climapro2RF (see photo) [this controller controls full function of the boiler i.e. heating, water, etc. It’s radio receiver sits inside the boiler and is connected by an EBUS Connecting Cable] & Glow Worm Outdoor Sensor.

After looking at the Nest manual I know that wiring should be done as per S-Plan but can’t figure out how?
Will the Glow Worm Climapro2RF including its radio receiver be replaced by Nest Learning Thermostat and the outdoor sensor be made redundant?

Are there any good deals on Nest Learning Thermostat available ?

Thank You in advance.
Community Updates
AskNestThermostat
7 Comments
28795726-9Hk24
28795728-ZQhFQ
28795729-AdRDN
28795745-h9FDb
28795747-yihoC
28795748-Kdl1O
28795755-g8Uqx
Post a comment
Avatar
@
    Text

    Top Discussions

    Top Discussions

    Top Merchants