Water Softener Drinking Water?

I am thinking of fitting a water softener to my mains cold water supply, my question is "Can I drink the water from it?"


No, it will turn your insides soft too and you'll eventually poop them out.


you need the lips attachment

Original Poster


According to this article, no.http://www.triangularwave.com/f7.htm

There are numerous articles that say you can and the referenced article is for American water supplies. Does anyone have a softener and is drinking the water? Will I really turn in to a big softie??

Yes you can but it does taste different - most people opt to have one tap (usually kitchen tap) which isn't connected to the softener system.

"Despite concerns about sodium and hardness levels in drinking water that have been raised spasmodically over the last forty years, the World Health Organisation advises that the decision whether or not to drink softened water should be limited only by whether or not you like the taste. WHO’s current, official position, published in the Guidelines for Drinking-water Quality 2006, is that no firm conclusions can be drawn on any possible health effects of sodium in drinking water.

The vast majority of softened water in the UK is safe to drink over the long term. Its suitability for drinking is measured by the levels of sodium in the water. To comply with the UK’s Drinking Water Regulation requirement for safe drinking water, sodium levels should not exceed 200 mg/l.

This policy is far from universal, though. In most of the European Union Member States, the national regulations lists sodium only as an indicator parameter, which does not contribute to the definition of whether water is fit to drink. In the USA there is no limit on sodium in the National Primary or Secondary Drinking Water Regulations.

Softeners work by replacing the hardness minerals with sodium. So, the more hard minerals in the water supply, the higher the levels of sodium in the softened water. For most areas of the UK, the sodium levels of softened water will be well within this limit. However, in a few parts of the UK where the drinking water is particularly hard, sodium levels may exceed 220 mg/l.

A reputable water softener supplier will always check your water hardness before fitting a softener. If drinking water should contains over 200ppm of sodium, it does not automatically become ‘dangerous’ to the majority of the population but it should not be used in the mixing of baby feeds or consumed by those on a low-sodium diet prescribed by a medical practitioner."


are you talking about the softener type that uses salt? if so, no, you have to plumb a bypass for any drinking water

if you want better drinking water you could plumb in a large drinking water filter, its like the brita jugs, but plumbed in and lasts months, and no jugs to fill

Original Poster

Thanks to all, decided to fit softener and plumb in separate filtered drinking water.



Thanks to all, decided to fit softener and plumb in separate filtered … Thanks to all, decided to fit softener and plumb in separate filtered drinking water.

good move. Soft water is disgusting compared to hard water when drinking (except in hot drinks). Then again, I wouldnt filter drinking water either.
Post a comment
    Top Discussions
    1. Meerkat Movies (2 for 1 Cinema Codes) | Official Trading Thread415314087
    2. What do you feel like whinging about today?1917250
    3. 75% off Sky TV for existing customers. Only works when you call the specifi…17386134
    4. Any PS4 News Here29213600

    See more discussions